BMR 93-02 F-Body Non-Convertible Only Driveshaft Tunnel Brace - Red

Increase floor and driveshaft tunnel rigidity on your Fourth Gen GM F-body with a Driveshaft Tunnel Brace from BMR Suspension. Built from 1-inch DOM steel tubing and CNC laser-cut 3/16-inch steel plate, BMR's DTB001 Driveshaft Tunnel Brace is designed to support and stiffen the factory floor and tunnel brace. This increases chassis rigidity increasing the overall feel during aggressive maneuvering. BMR's DTB001's Driveshaft Tunnel Brace strengthens the floor and driveshaft tunnel for increased chassis stiffness. The design reinforces key points of the floor, effectively reducing deflection when lateral loads are applied to the chassis.

BMR Suspension designed the DTB001 Driveshaft Tunnel Brace for any application. This 100% bolt-on brace uses existing boltholes and hardware, allowing for easy installation with simple hand tools. Once installed, the Driveshaft Tunnel Brace reduces floor and driveshaft tunnel deflection with no change in NVH. This increases steering feel and stability on both the street and track.

***NOTE - WILL NOT FIT CONVERTIBLE CHASSIS. NOT COMPATIBLE WITH BMR TRAK PAK.***

BMR Suspension's DTB001 Driveshaft Tunnel Brace is available in black hammertone and red powdercoat for long-lasting good looks. Installation time is less than1 hour. Proudly made in the U.S.A.!

Vehicle Fitment

• 1993-2002 Chevrolet Camaro
• 1993-2002 Pontiac Firebird

Please verify exact fitment for your trim and engine before ordering.

Manufacturer Part Number: DTB001R

Images are for illustrative purposes only. Actual product may vary.

⚠ WARNING (California Proposition 65): This product can expose you to chemicals which are known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov.